LELY Splendimo 165 L - Change of grease in mower elements

7.6 Change of grease in mower
elements
Replace the grease in the mower elements every 500 working
hours or every 1,000 hectares.
Follow the directions listed hereafter.
- Remove the mower disc.
- Dismount the bearing housing A (fig. 23) from the element.
Make sure that the shims B remain in place.
If several bearing housings need to be dis- mounted, care
should be taken that they are fitted back on the original
mower elements.
- Remove the grease from the element. Do not use a solvent
since it may affect the sealing of the bearings and/or rinse
the grease fill out of the bearings.
- Fill the elements with 95 grams of grease (grease classi-
fication NLGI 0, type calcium-lithium soap or lithium
soap/Shell Alvania WR 0).
Measure the grease quantity carefully. An incorrect
quantity may cause overheating and damage of the
element .
- Place the bearing housing on the element. Turn the hub C
(fig. 23) so that it is aligned with the hub of the adjacent
mower element (fig. 24).
- Apply Loctite 243 to the thread of the fillister head screws
and tighten them with a torque of 39 Nm (3,9 kgm) for
mower unit with castellated nut.
- Check the presence of the O-ring in the pressure piece
- Fit the mower disc. Tighten the castellated nut with a
torque of 150-250 Nm (15-25 kgm) and secure it with a
split pin. Make sure that the split pin does not protrude
above the pressure piece.
40
23
39 Nm (3,9 kgm)
0.095 kg
NLGI 0
C
A
B
24
150-250 Nm (15-25 kgm)
!
!