- Remove the nut (7) and the ring (8).
- Remove the end plate (9) as well as the swathboard.
- Slide the mower elements and intermediate spacers from
the connecting rod (3).
Only for SPLENDIMO 360 T mower:
- Dismount the additional coupling bar (fig. A-2) as follows:
• Loosen the nut (A) by a few turns.
• Remove the bolts (B) and spring washers.
• Remove the coupling bar and support arm (C) as well as
the spacer (D).
Assembly of the cutter bar takes place in the reversed order.
Mind the directions listed hereafter.
- Clean the centring rings (10) and the contact areas of the
mower elements and intermediate spacers.
- Make sure that there is no contamination between those
elements and spacers which were not dismounted.
- Fit the elements in the standard configuration of directions
of rotation (fig. A-3) or in a configuration at your choice
(“S” model mower discs only).
41Supplement A
A-3
A-2
SPLENDIMO 240 TS
SPLENDIMO 280 TS
SPLENDIMO 320 TS
SPLENDIMO 320 TN
SPLENDIMO 280 TN
SPLENDIMO 240 TN
SPLENDIMO 360 TS
SPLENDIMO 360 TN
A
B
C
D
To Next Page
Loading...