B OPTIONAL EXTRAS
Skids
Skids fitted underneath the cutter bar ensure that the
SPLENDIMO mower follows the ground contours more
easily. Due to the streamlined shape of the skids, the mower
does not dig into the ground in case of unevenness while at
the same time soil is prevented from building up underneath
the discs. In addition to this, the skids make sure that the
ground pressure is distributed more evenly across the width
of the cutter bar.
Wear plates
To avoid excessive wear and tear of the skids as a result of
abrasion, the SPLENDIMO mower can be equipped with
wear plates that are fitted underneath the skids.
These wear plates can be replaced easily and at low cost.
They come in a thickness of 4 or 8 mm.
Topping skids
By fitting so-called ‘topping skids’ underneath the skids, the
cutter bar of the SPLENDIMO mower is enabled to mow
somewhat higher above field level in rough conditions. In
that case, the mowing height also increases by approx. 7 cm
so that the knives do not dig into the ground. This may be
important when mowing fallow lands or in nature landscapes.
The turf is spared because the knives do not dig into the
ground. The cutter bar, too, is spared since it is not hit by
stones, branches etc..
Swath board kit
To reduce swath width, a special kit can be fitted to the
SPLENDIMO mower so that no grass is run on by the tractor
wheels.
Stabilisation chain
Correct height of the hydraulic linkage is essential to the
machine’s freedom of movement, so it should be maintained
after initial adjustment.
For tractors that do not have a consistent linkage height, a
stabilisation chain can be supplied to steady the lower
linkage position.
43Supplement B
To Next Page
Loading...
Need help?
General
