To Next Page
А
АдисFeb 11, 2026
почему кондер 10мкф 100в пробивает заменяю лопается
почему кондер 10мкф 100в пробивает заменяю лопается
Ensure electrical system grounding, correct mains voltage, and undamaged power cord before connecting.
Turn on the amplifier after other equipment and turn it off before others, with gain controls minimized.
Install in locations with correct air circulation, avoiding direct sunlight, heat, dust, and moisture.
Use balanced signal cables for mixer outputs and power cables for loudspeakers. Ensure good cable condition.
Balanced XLR-F connectors for receiving line signals.
Balanced JACK connectors for daisy-chaining signals to other units.
General