Need help?Do you have a question about the LEM PROCON PLUS 2200P and is the answer not in the manual?
Covers critical warnings on electrical shock, hearing protection, proper installation, ventilation, and servicing procedures.
Connect amplifier to mains socket ensuring proper grounding and voltage match.
Always switch amplifier on last and off first in a system, with gain controls minimized.
Install in well-ventilated areas, away from heat/sunlight, ensuring airflow around the unit.
Use balanced cables for mixer and power cables for loudspeakers, check cable condition.
Avoid RF sources, address ground loops with SHIELD switch.
Protect during transport, clean dust with compressed air, avoid opening.
Contact authorized service for repairs; do not attempt unauthorized servicing.
Explains power switch, LEDs, input attenuators, signal meters, and limiter indicators.
Details XLR inputs, JACK link connectors, SPEAKON/BINDING POST outputs, and STEREO/BRIDGE modes.
Details output power, input sensitivity, impedance, frequency response, gain, slew rate, damping, crosstalk, S/N ratio, THD, IMD.
Covers thermal protection, short circuit protection, current sensor, soft-start, controls, indicators, connectors.
Provides information on power supply, unit dimensions, and weight.
Illustrates how to connect the amplifier and speakers for stereo operation.
Demonstrates wiring for parallel operation of speakers with the amplifier.
Shows the setup for bridging two amplifier sections for mono operation.
Covers critical warnings on electrical shock, hearing protection, proper installation, ventilation, and servicing procedures.
Connect amplifier to mains socket ensuring proper grounding and voltage match.
Always switch amplifier on last and off first in a system, with gain controls minimized.
Install in well-ventilated areas, away from heat/sunlight, ensuring airflow around the unit.
Use balanced cables for mixer and power cables for loudspeakers, check cable condition.
Avoid RF sources, address ground loops with SHIELD switch.
Protect during transport, clean dust with compressed air, avoid opening.
Contact authorized service for repairs; do not attempt unauthorized servicing.
Explains power switch, LEDs, input attenuators, signal meters, and limiter indicators.
Details XLR inputs, JACK link connectors, SPEAKON/BINDING POST outputs, and STEREO/BRIDGE modes.
Details output power, input sensitivity, impedance, frequency response, gain, slew rate, damping, crosstalk, S/N ratio, THD, IMD.
Covers thermal protection, short circuit protection, current sensor, soft-start, controls, indicators, connectors.
Provides information on power supply, unit dimensions, and weight.
Illustrates how to connect the amplifier and speakers for stereo operation.
Demonstrates wiring for parallel operation of speakers with the amplifier.
Shows the setup for bridging two amplifier sections for mono operation.
To Next Page
General