LEMEGA DR1 User Manual

10
11
12
10 DC power in (5V) 12 Battery compartment.
11 Headphones out.
ACCESSORIES INCLUDED
Carefully remove the unit and all accessories from the package.
Please verify that you have all the following accessories before
recycling the gift box.
Owner's Manual
Warranty Card
Power charging cable
GETTING STARTED
UNDERSTANDING THE CONTROL FUNCTIONS
QUICK SETUP
Fully extend the Telescopic antenna to ensure good reception in
both DAB and FM Radio modes. It may be necessary to alter the
position of the DAB Digital Radio and/or the Telescopic antenna to
achieve the best signal.
1
2.
3.
4
5.
6.
7.
1.
.Connect the power cable to the input in the side of the DR1 and
then plug the cable into an outlet or insert the four “AA” batteries into
the battery compartment to power on.
Fully extend the rear telescoping antenna.
Press the Power knob on the front to turn on the DR1.
. When powered on for the first time in DAB mode, the DR1 will
initiate an auto scan. When complete,
The display will indicate how many stations were received. Be sure
the rear antenna is fully extended during the auto scan.
Press the SOURCE button to select the desired source.
Adjust the volume to the desired level using the SELECT knob.
In DAB mode, the TUNE+/TUNE- button allows you to navigate
between different stations.
GUIDE TO FEATURES
PRESET1/2/3+:
Store a station to the preset list - to store a station,
selected your desired radio station, then press
and hold the PRESET 1/2 button for a second
until the LCD display “Preset store #:(Empty)”
to fig.17, or“#: saved radio station” to fig.18.
There are 10 DAB presets and 10 FM presets.
Either press the TUNE+/TUNE- button to select
your desired station preset number or rotate
and push on the SELECT knob to confirm
your selection, the display will show
“Preset # Stored” to fig.19.
Preset 10 DAB stations and 10 FM favorite
Recall a station from the Preset list
1.To recall a preset station, press the “3+” button once, or rotate the
Select knob to select presets station that you have stored. When the
display shows your desired preset number push SELECT knob to
confirm.
Note: If you choose a preset that hasn't been allocated a station,
then “Empty” will be displayed.
stations.
REAR VIEW
3 4

LEMEGA DR1 Specifications

Power

power output	1CH X 2W
power supply	5V DC or 4AA batteries

Weight and Dimensions

weight	0.45 kg
dimensions	175 x 106 x 54 mm