Operating Instructions
(1) How to Safely Power Your Machine On, Use It, and Turn It Off
• Select a treatment accessory. On the accessory, you will find two cables with connector plugs on
the end. Insert each plug into the matching adapters on the front panel of the PEMF 4000
machine. Once inserted, twist gently to the right to lock the plug into place. You will feel a
gentle click when the plug enters the locked position. Do NOT power on the machine until your
treatment accessory is connected in this way.
• Plug the machine into an 110V 50/60 cycles outlet. Avoid plugging it into outlets that are
connected to a light dimmer.
• Flip the Power Switch on the bottom of the front panel. It will light up green. You will hear fans
turn on inside the machine. The Stop button on the front panel will light up red.
• Set how long the session should last. Turn the radial dial on the Timer anywhere from 1 to 30
minutes. When the timer reaches the time you set, the session will end.
• Press the Start button to start the session. The Start button is located directly above the red Stop
button. When the session starts, the Start button will light up green and the Stop button will go
dark. You will hear the machine make a rhythmic popping sound. As long as this popping
continues, the treatment is in session.
• To stop the treatment before the timer runs out, press the Stop button. It will light up red and the
popping sound will stop. Sometimes, one extra pop may go even after the button has been
pressed. This is normal and safe discharge of unused energy in the machine from the session. If
you press the Start button again, the timer will start over from the beginning for a fresh session.
• After the timer runs out or the Stop button is pressed, you may power down the machine. Flip
the green Power Switch to the off position to turn off the machine. Do NOT flip this switch
while a treatment is in session.
• When the Power Switch is in the off position and the machine is fully powered down, you may
remove the accessory plugs from the adapters in the front panel. To remove the plugs, pull back
on the silver locks with your thumb, twist the plug to the left, and gently pull back to remove
the plug from the adapter. Do NOT remove the treatment accessory while the machine is
powered on.
To Next Page
Loading...