How to Treat Yourself and Others
(1) How to Use the Treatment Rope (arranged from weakest to strongest treatment)
• No coil – Simply hold the treatment rope up to the area to be treated. This is best for sensitive
areas such as the eyes, mouth, neck and other areas near the head.
• Direct wrap – Wrap the rope around the body part to be treated. Increase the number of times
the rope wraps around this body part to increase the treatment strength.
• Loop coil – Arrange the rope into a coiled loop. The more loops you add to the coil, the stronger
the treatment will be proportionate to the amount of rope used. In other words, the more rope
you use to make your coil the stronger the treatment will feel. When creating a loop coil with
the rope, make each loop round in shape and at least 12 inches in diameter for a moderate
strength treatment. Hold the center of the coil up to the body part to be treated from multiple
angles for best results. Experiment by holding the loop at different distances from the body to
find the ideal comfort level.
(2) Basic Protocol for Treating Yourself, Others and Animals
A. Identify the Source of Pain – Locate the source of pain in your or your patient's body. Touch it if
possible to get a sense of its size, shape and exact location. If the pain is all over, try to identify
where it is the strongest or the most swollen. This is where the treatment will begin.
B. Rate the Pain on a Scale of 0 (No Pain) to 10 (Extreme Pain) – This will give you a good gauge
from which to measure your results immediately after treatment and over the next week as you
monitor your progress. If you will be treating regularly it may prove useful to write this number
down before the Session and again after the Session for future reference.
C. Prepare the Rope – Take the treatment rope (or other accessory) and plug each end of the cable
into the top slots on the front panel of the unit. After inserting, secure each plug by gently
twisting it clockwise until it clicks into place. To remove the cables after powering down the
unit, pull the silver locks back with your thumb and twist the plug counter clockwise.
D. Power the Device On – Plug the power cord into the wall (or specific adapter). You will see a
Power Switch at the bottom of the front panel. When it is flipped into the ON position it will
light up green. Do not switch it on until the treatment accessory is attached.
E. Set the Timer – Each machine ships with the option to treat for up to 30 minutes. If you turn the
timer up all the way, it will pulse continuously without running out. The timer dial does not
move by itself. The end of the treatment will be marked by the green Start button dimming and
the red Stop button lighting up. Average treatment duration is 1 to 5 minutes.
To Next Page
Loading...