16
Resetting the Unit
If the unit experiences a power surge or electric shock, it is possible that
the internal micro-controller may lock up and the unit will not respond to
any commands from the panel controls.
1. In this event, unplug and then reconnect the AC po wer plug
into the wall outlet.
2. Use a straightened paper clip, toothpick or similar objects to
press the RESET button located at the rear of the main unit
(see the below figure). The reset operation clears the system
memory and all of your previous settings will be erased.
CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE
RESET BUTTON.
IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.
RESET button
To Next Page
