LENCO LED-2213 - Page 24

1.1.1.2 Transponder
You can select the c urrent Transponder or add the new Transponder.
1.1.1.3 Local Frequency
You can change the local frequency.
Note: You must press OK to save this local frequency when the cursor is on the Local
Frequency item before you select another satellite.
1.1.1.4 22K Tone
You can change the 22k tone. Press LEFT/RIGHT select
ON, OFF
or
AUTO.
Note: You must press OK to save this 22K tone when the cursor is on the
22K Tone
item
before you select another satellite.
1.1.1.5 Polarity
You can change the polarity. Press LEFT/RIGHT select
13V, 18V, 13/18V or OFF
.
Note: You must press OK to save this polarity when the cursor is on the
Polarity
item before
you select another satellite.
1.1.1.6 DiSEqC Switch
You can change DiSEqC Switch. Press LEFT/RIGHT select
LNB1, LNB2, LNB3, LNB4 or
OFF.
Note: You must press OK to save this DiSEqC Switch when the cursor is on the
DiSEqC
Switch
item before you select another satellite.
1.1.1.7 Antenna mode
You can change t he Antenna mode. P ress LEFT/RIGHT select
Fixed, Goto x or DiSEqC1.2.
When you select
Goto x::
Press OK to enter the submenu of the
Adjust Antenna
.
Press UP/DOWN to move the curser to the item of the
Transponder.
Press LEFT/RIGHT to select the c urrent transponder.
Press UP/DOWN to move the curser to the item of the Satellite Longitude.
Input the data of the Satellite Longitude and press LEFT/RIGHT select
East
or
West.
Press UP/DOWN to move the curser to the item of the
My Longitude.
Input the date of the My Longitude and press LEFT/RIGHT select
East
or
West.
Press UP/DOWN to move the curser to the item of the
My Latitude.
Input the date of the My Latitude and press LEFT/RIGHT select
South
or
North
.
Press UP/DOWN to move the curser to the item of the
Goto Position.
Press OK to move the Antenna to the position you want.
22