LENCO SCD-720 - Page 16

-16-
OTHER FUNCTIONS
AUX IN
This allows you to connect the sound from an external player through your unit.
1. Plug a 3.5mm audio cable (not included) into your external player line out and the other end into the AUX IN jack.
2. Press the SOURCE button to enter AUX mode. Display shows “AUDIO IN”.
3. Start your external player to play music.
4. The unit plays the sound.
EQ OPERATION / X BASS
You can enjoy di󰀨erent EQ sound e󰀨ect modes. Press the EQUALIZER button on the remote control will change to di󰀨erent
sound e󰀨ects of FLAT / ROCK / CLASSIC / POP / VOCAL / JAZZ.
You can also boost the bass e󰀨ect of the music. Press the X BASS button on the remote control will toggle the X Bass e󰀨ect
between ON and OFF.
Note:
- When X-Bass is enabled, the EQ sound e󰀨ect will be disabled. Pressing EQUALIZER button will only show X-Bass On
without any EQ e󰀨ect. To resume the EQ sound e󰀨ect, press the X-BASS button to turn o󰀨 rst.
SLEEP FUNCTION
1. When the unit is switched on, press the SLEEP button on the remote control repeatedly to select a sleep duration from
either SLEEP OFF, 90, 80, 70, 60, 50, 40, 30, 20 or 10 minutes. When the sleep timer is set, the remaining timer will
periodically be shown on the display.
2. When the sleep timer is zero, the unit will turn o󰀨 automatically.
3. To cancel the sleep function, press the STANDBY button to turn o󰀨 the unit. Or press the SLEEP button repeatedly to
select “SLEEP OFF”.
LANGUAGE SETUP
You can set the language of the unit.
1. Turn on the unit in DAB+ mode or FM mode.
2. Press and hold the MENU button (or press the MENU button on the remote control) to access the menu control.
3. Press the
or button until “System” is displayed and then press the ENTER button.
4. Press the
or button until “Language” is displayed and then press the ENTER button.
5. Press the or button to toggle between di󰀨erent languages. Select your desired language and then press the
ENTER button to conrm.
6. Press the MENU button to exit the menu control.
SOFTWARE VERSION CHECK
You can check the software version of the unit.
1. Turn on the unit in DAB+ mode or FM mode.
2. Press and hold the MENU button (or press the MENU button on the remote control) to access the menu control.
3. Press the
or button until “System” is displayed and then press the ENTER button.
4. Press the
or button until “SW ver” is displayed and then press the ENTER button to show the software version
number.
5. Press and hold the MENU button (or press the MENU button on the remote control) to exit the menu control
FACTORY RESET
This function resets the unit to the original factory settings.
1. Turn on the unit in DAB+ mode or FM mode.
2. Press and hold the MENU button (or press the MENU button on the remote control) to access the menu control.
3. Press the or button until “System” is displayed and then press the ENTER button.
4. Press the
or button until “Reset” is displayed and then press the ENTER button.
5. Press the
or button until “Yes” is displayed and then press the ENTER button to reset the unit.
ENERGY SAVING
Due to ErP requirement and protect the environment, the unit will turn o󰀨 to the standby mode automatically once no music
has been playing around 15 minutes.
When the unit is power o󰀨 due to ErP, you can press the STANDBY
button to turn on the unit again.