LENCO SCR90 - Page 7

PROGRAM PLAYBACK
PROGRAMMED PLAYBACK
Programmed playback enables tracks on a disc to be played in the desired order. Up to 20 tracks can be programmed.
1. Press the " PROGRAM " button.
2. Press the " Р.5КІР " апа " B.SKIP " buttons to select the desired track number.
3. Press " PROGRAM " button again to memorize the track.
4. Repeat steps 2 and 3 until all desired tracks аге programmed.
5. Press the " PLAY/PAUSE " button to start. " PROGRAM " is flashing on the CD display.
6. Press" STOP " button to stop programmed playback.
7. Press" PROGRAM " and " PLAY/PAUSE " buttons to resume programmed playback.
8. Open the CD door or turn off the CD player to clear the programmed memory.
Note : Programming can only be made when the player is in stop made.
"PROGRAM "
aN aN TN AS
CD display
Note on CD-R/RW discs
- Because of non-standardized format definition’ production of CD-R/RW, playback quality and performance аге not
guaranteed.
- Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions, such as PC performance,
-6 writing software, media ability, etc.
®- - Do not attach а seal or label іо either side of the CD-R/RW disc. It may cause а malfunction.
TAPE PLAYBACK
ў. ЗО TAPE з. Press the < PLAY button. PLAY
FUNCTION
TAPE O
= Бу
ra “i
4 TO STOP PLAYBACK
Press the STOP / EJECT button.
2. Insert the cassette. Бус
NA
Э
ТО INTERRUPT PLAYBACK
Press the PAUSE button.
To resume play, press the PAUSE button again.
TO FAST WIND
Press the REWIND or F.FWD button. Press the
STOP/EJECT button to stop winding at the desired
position.
GB5
| SCR90-LENCO-ENG-TCD06. p65 7 5 12/8/2005, 6:11 РМ