LENCO SCR90 - Page 8

MAINTENANCE
CLEANING CD
If the CD skips or will not play , the disc may need cleaning . Before
playing, wipe the disc from the centre out with a cleaning cloth. After
playing, store the disc in its case.
CLEANING THE TAPE HEADS
To maintain optimum sound quality, clean the playback heads (а)
,erasure head (Б), pinch rollers (с), and capstans (d) regularly (every
10 hours of use ). Use a cotton swab lightly moistened with cleaning
fluid or denatured alcohol.
CLEANING THE CD LENS
If the CD lens is dusty, clean itwith a brush-blower. Blow several times
оп the lens and remove the dust with the brush. Finger prints тау be
removed with a cotton swab moistened with alcohol.
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly wiping with
a soft cloth.
IMPORTANT NOTE
If an abnormal display indication or an operating problem occurs,
disconnect the AC power cord and remove the batteries, Wait at least
5 seconds, then reconnect the AC power cord or reinstall the batteries.
WARNING
Should the CD door be opened before the reading of the CD completed,
ajamming noise may occur. This is resolved by closing the CD door.
SPECIFICATIONS
CASSETTE SECTION
Track format:
Erasing system:
Tape speed:
FF. & REW time:
Frequency response:
CD SECTION
Channels:
S/N ratio:
Wow & Flutter:
Sampling frequency:
Quantization:
Pick up light source:
Pick up wave length
RADIO SECTION
Tuning ranges:
Antennas:
GENERAL
Output power:
Power consumption:
Speaker:
Phones jack:
Power source:
Dimensions:
Weight
2 track stereo
Magnetic erase 6 poles
4.75 cm / вес.
170 sec. (F-60 tapes)
125 Hz - 8000 Hz (Normal tape)
2 channels
60 dB
undetectable
44.1 kHz 8 x over sampling
1 bit DA converter
Semi - conductor laser
790 nm
FM 87.5 - 108 MHz
FM Rod antenna
1.2W + 1.2W (RMS)
13W
3" 8 OHM
3.5MM
АС: 230V / 50Hz
(INDICATED ON THE REAR OF THE UNIT)
DC: 12V 1.5 x 8 UM2 / R14 / "С" SIZE
290(L) x 273(D) x 163(H)mm
2.3KGS
Due to continuing improvement, the features and the design are subject to change without notice.
Where to place the item :
Today's furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive
range of cleaning products. Therefore, the possibility that some of these substances contain components that react
adversely to the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the
If necessary, place the appliance on a non-slide surface.
appliance can cause discoloring to furniture surfaces.
If at any time in the future you should need to dispose of this product please note that: Waste electrical
products should not be disposed of with household waste.
Check with your Local Authority or retailer for recycling advice.
Equipment Directive)
| SCR90-LENCO-ENG-TCD06.p65 8
GB6
Ф
Please recycle where facilities exist.
(Waste Electrical and Electronic
12/8/2005, 12:43 PM