• 5 •
7
8
9
345 21
6
235
370
200
100
50
65
9-10 mm
Application Guide • COMFAIR HD-AGU-1107-E
Important! It is recommended that wall-mounted water-fi lled fan coils are
installed with ON/OFF devices.
1: Supply pipe (return)
2: Supply pipe (delivery)
3: Condensate drain pipe
4: Clamp for fi xing the condensate drain/connecting pipe
5: Condensing collecting tray
6: Condensate outlet
7: Fan coil anchoring plate
8: Screws for mounting plate assembly
9: Valve body
INSTALLATION - HD
INSTALLATION WITH BUILT-IN VALVES
Proceed as shown bellow to assemble the mounting plate.
OUT
IN
From HD
To HD
CAUTION! Check that the highlighted measurement is exact
1. Identify the position on the wall where the fan coil is to be installed
and create a niche with the dimensions shown bellow:
2. Cover the bottom edge of the niche with a steel angle bar
(NOT supplied). Apply the mounting plate and fi x it using four
screws and four screw anchors in the relative holes:
ANGLE BAR
3. Fix the condensate collecting tray by inserting two self-tapping
screws into the relative holes. The external surface of the tray must
be fl ush with the wall:
4. Position the fan coil on the mounting plate:
5. Tilt the fan coil and insert the relative polystyrene foam spacer
so that the valves can be easily reached and connected to the
appliance and to the mains water supply:
6. Connect the hoses to the fan coil supply pipes and the condensate
drain hose:
To Next Page
Loading...
