Page 23
9 - Use a utility knife to cut out the cabinet insulation
for the right side vent / air intake. 10 -Install the two
90° street elbows (provided) through the side of the
cabinet. The male side of each elbow should extend
down through the blower deck and connect to the
rubber ttings below. Once the elbows are properly
positioned, tighten each clamp.
10 - Install the two 90° street elbows (provided) through
the side of the cabinet. The male side of each
elbow should extend down through the blower deck
and connect to the rubber ttings below. Once the
elbows are properly positioned, tighten each clamp.
11 - Peel protective backing from side vent sealing
gaskets (2) and apply to side vent sealing plates (2)
as shown in FIGURE 19.
12 - Install the side vent sealing plates and gaskets on
the exterior of the cabinet as shown in FIGURE
19. Secure with six mounting screws (four reused
and two provided from bag assembly). Holes are
pre-punched in the parts and cabinet, no drilling is
required.
13 - Install sheet metal screws (provided) to seal extra
two holes in cabinet not used with side vent clamps
IMPORTANT
Side vent sealing plates and side vent sealing
gaskets must be used when converting to right side
venting. Failure to use gaskets and plates may lead
to improper operation of unit.
Exhaust/Air
Intake Connections
Pipe Clamp
Hose Clamp
FIGURE 17
Sheet Metal
Patch Plate
Patch Plate Top Cap
FIGURE 18
Right Side Vent Configuration
Side Vent
Sealing Plate
Side Vent
Sealing Gaskets
Street Elbows (2)
Intake
Exhaust
FIGURE 19
To Next Page
Loading...
