41
Safe lighting and other performance criteria were met with the gas manifold and control assembly provided on the boiler
when the boiler underwent tests specied in ANSI Z21.13-latest revision.
is appliance is equipped with an ignition device which A.
automatically lights the pilot. Do not try to light the pilot
by hand.
BEFORE OPERATING smell all around the appliance B.
area for gas. Be sure to smell next to the oor because
some gas is heavier than air and will settle on the oor.
What To Do If You Smell Gas
Do not try to light any appliance.•
Do not touch any electrical switch; do not use any phone •
in your building.
Immediately call your gas supplier from a neighbor’s •
phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the re depart-•
ment.
Use only your hand to move the system control switch. C.
Never use tools. If the switch will not move by hand,
don’t try to repair it, call a qualied service technician.
Force or attempted repair may result in a re or explo-
sion.
Do not use this appliance if any part has been under wa-D.
ter. Immediately call a qualied service technician to in-
spect the appliance and to replace any part of the control
system and any gas control which has been under water.
STOP! Read the safety information above on this label.
1.
Set thermostat to lowest setting.
2.
Turn o all electric power to the appliance.
3.
is appliance is equipped with an ignition device which
4.
automatically lights the burner. DO NOT try to light the
burner by hand.
Remove the front jacket
5.
panel.
Turn the gas control
6.
knob clockwise to
“OFF”.
Wait ve (5) minutes to clear out any gas. en smell for
7.
gas, including near the oor. If you smell gas, STOP! Fol-
low “B” in the safety information above on this label. If
you don’t smell gas go on to next step.
Turn the gas control knob counterclockwise
8.
to
“ON”.
Replace front jacket panel.
9.
Turn on all electrical power to the appliance.
10.
Set the thermostat to desired setting.
11.
If the appliance will not operate, follow the instructions
12.
“To Turn O Gas To Appliance” and call your service
technician or gas supplier.
OFF
ON
INLET
GAS CONTROL KNOB
SHOWN IN "ON" POSITION
Set the thermostat to lowest setting.
1.
Turn o all electric power to the appliance if service is to
2.
be preformed.
Remove the front jacket panel.
3.
Turn gas control knob clockwise
4.
to “OFF”.
Replace the front jacket panel.
5.
If you do not follow these instructions exactly, a re or explosion may result causing property damage, personal injury or loss
of life
WARNING
!
To Next Page
Loading...
Need help?
General
