★
●
●
●
●
●
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
When replacing the batteries, do not use old or different types of batteries,
If the remote controller is not be used for a long time, please
otherwise, it may cause malfunction.
remove batteries to prevent batteries from leaking.
The operation should be performed in its receiving range.
To avoid any interference with infrared signals, please keep your
remote away (at least 1m) from other infrared sensing electrical
equipment e.g. stereo or TV sets
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds. If it still doesn't operate properly,
Notes:
replace the batteries.
Fig.1
Fig.
2
Replacement of Batteries
Press "+ " and "-" buttons simultaneously
to lock or unlock the keypad.
At unit OFF, press
"MODE"
and " - " buttons simultaneously to switch between and .
℃
℉
4
TIMER:
Press this button to initiate auto-on/auto-off timer. To cancel auto-timer program, press
this button twice.
8
Operation of Remote Controller
Combination of "+" and "-" buttons: About lock
9
Combination of "MODE" and "-" buttons: About switch between fahrenheit and cenrigrade
9
10
Under switch-on or switch-off state, you may hold "+" and "FAN" buttons simultaneously for
3 seconds to set the lamp on or off and send the code. After being energized, the lamp is
defaulted on.
Combination of "+" and "FAN" buttons: About Lamp
11
To Next Page
Loading...
Need help?
General
