If wireless remote controller is lost, you can use the control panel and operate manually.
Note:
VENTILATION LEVER
Ventilation Lever
When the slider at the: When the slider at the:
Remote control panel
1
ON/OFF BUTTON
Operation starts when pressing this button, and stops
when pressing this button again.
2
FAN SPEED BUTTON
Select the fan speed HIGH, MID, LOW and AUTO in sequence.
3
4
TIME/TEMP BUTTON
MODE BUTTON
5
SIGNAL RECEIVER
6
SWING BUTTON
Activate the automatic air swing function.
7
FILTER BUTTON
1
5
6
4
4
2
3
7
Press the∧keypad to increase the set (operating)
temperature of the unit.and Press the∨keypad to
decrease the set (operating) temperature of the unit.
The temperature seting range is from 16~30℃
Press the∧keypad also to increase the selected time
in 1 hour increments,and Press the∨keypad to
decrease the selected time in 1 hour decrements,The
time seting range is from 0~24 hours.
Select the operation mode, AUTO, COOL, DRY, FAN,
HEAT (for reverse cycle model) or AUTO,COOL, DRY,
FAN (for cooling only model).
This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation and
cooling. The LED (light) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press the
"Check Filter" button and the light will go off. Before the
LED(light) illuminate, press the "Check filter" button until
after 3 seconds, the accumulated time of. Operation will be
canceled.
CLOSE
VENT OPEN
CLOSE
VENT OPEN
-"OPEN" position,the ventilation door
opens to allow air,smoke or odors to
be expelled from the room.
-"CLOSE" position,the ventilation door
is closed and the air will be circulated
inside the room and conditioned.
To Next Page
Loading...
Need help?
General
