Page 17
OHR23 Start−Up & Performance Check List
Job Name Job no. Date
Job Location City State
Installer City State
Unit Model No. Serial No. Service Technician
HEATING SECTION
Electrical Connections Tight? Supply Voltage Blower Motor Amps
Blower Motor Burner Model No. Serial Number
Piping Connections Tight? All Valves Open? Blower Motor Lubrication OK?
Oil Pump Pressure (recommended minimum 140 psi)
PROPER DRAFT
Draft Reading (recommended .03 to .04 inches w.c.)
Percent CO
2
(recommended 12%)
Flue Connections Tight? Fan Control Setting (maximum 130F 55C)
Percent CO
2
(recommended 12%)
Fan Control Cutout Temperature Rise
Filter Clean & Secure? Vent Clear?
THERMOSTAT
Calibrated?
Heat Anticipator
Properly Set? Level?
To Next Page
Loading...
