C-Heating Startup
FOR YOUR SAFETY READ BEFORE LIGHTING
Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
-
explosion.
OFF and return the thermostat switch to HEAT to reset
ignition control
WARNING
Danger of explosion. Can cause injury or
death. Do not attempt to light manually.
Unit has a direct spark ignition system.
WARNING
injury or product or property damage. You
must follow these instructions exactly.
1 - Set thermostat to lowest setting.
2 -
3 - This appliance is equipped with an ignition device
which automatically lights the burner. Do not try to
light the burner by hand.
Open or remove the heat section access panel.
5 - Move gas valve switch to OFF
STOP! Immediately call your gas
supplier from a neighbor’s phone. Follow the gas
to the next step.
7 - Move gas valve switch to ON.
Close or replace the heat section access panel.
Turn on all electrical power to appliance.
Set thermostat to desired setting.
NOTE - When unit is initially started, steps 1 through
9 may need to be repeated to purge air from gas
line.
11 - The ignition sequence will start.
12 -
ignitions before locking out.
13 -
your service technician or gas supplier.
Gas valve shown in ON position.
MANIFOLD
PRESSURE
OUTLET
INLET
PRESSURE
PORT
MANIFOLD
PRESSURE
ADJUSTMENT
SCREW
FIGURE 14
White Rodgers 36J54 Gas Valve
Two-Stage
Gas valve shown in OFF position.
LOW FIRE
ADJUSTMENT
HIGH FIRE
ADJUSTMENT
INLET
PRESSURE
TAP
MANIFOLD
PRESSURE TAP
FIGURE 15
1 -
lowest setting.
2 -
power to the appliance.
3 - Open or remove the heat section access panel.
force.
D-Safety or Emergency Shutdown
valves.
To Next Page
Loading...
Need help?
General
