Lenovo ThinkPad E590 - Page 43

4. Loosen the screws that secure the base cover assembly 1 , pry up the latches 2 , and then remove the
base cover assembly
3 .
5. Install the new base cover assembly in place 1 and ensure that the latches of the base cover assembly
are secured in place
2 . Then, tighten the screws 3 .
6. Turn the computer over. Connect the ac power adapter and all disconnected cables to the computer.
Troubleshooting
If the computer does not start up after you reinstall the base cover assembly, disconnect the ac power
adapter and then reconnect it to the computer.
Chapter 6. CRU replacement 37