If the LanguageOverride is empty, has an invalid value or the NLS language pack
specified in the LanguageOverride field is not installed on the computer, then
EasyUpdate gets the language code from the operating system regional settings. If
EasyUpdate successfully loads the regional settings language, then that is the
language EasyUpdate displays for the rest of the session.
If the language pack corresponding to the regional settings language is not on the
system, then EasyUpdate will attempt to load the default language that the end
user selected at installation time through the EasyUpdate installer. EasyUpdate gets
the default language value from the DefaultLanguage field in the EasyUpdate
location of the registry. If the default language pack is on the system, then the
default language will be used for the rest of the session. If the DefaultLanguage
field is empty, has an invalid value or if the language pack that corresponds to the
default language is not on the system, then the default language is not used.
If EasyUpdate is unable to load the language pack defined in the DefaultLanguage
field, then it attempts to load the US English language pack. If the US English
language pack is not on the system, then you will see a message that reads:
EasyUpdate has found a critical problem and must close. This error message is in
the US English language.
Update Retriever languages
Update Retriever function is similar to EasyUpdate but it supports fewer translated
languages. Update Retriever is available in the following languages:
Table 2.
Language Identifier Language Override Code
English 1033 EN
French 1036 FR
German 1031 DE
Japanese 1041 JP
Simplified Chinese 2052 CHS
The registry locations for the LanguageOverride fields are:
HKEY_LOCAL_MACHINE\SOFTWARE\Lenovo\Update Retriever\LanguageOverride
Installation considerations
EasyUpdate and Update Retriever are installed as standalone applications and
deployed with default preferences for all configuration options. The installation
scenarios listed below are supported as follows:
v Clean installation
EasyUpdate and Update Retriever are installed with default preferences for their
respective configurable options.
v Upgrade or over-install (current version already exists)
The installer will remove the old version of EasyUpdate or Update Retriever and
install the new version. Your network share repository folder and contents will
be preserved.
When
installing, a shortcut is added to the following Start menu folder for
ThinkServer systems:
v For EasyUpdate:
Chapter 2. Installation 7
To Next Page
Loading...
Need help?
General