Figure 35. Removing the drive from the drive bay
5. Remove the four screws and then take the drive out of the Lenovo ThinkServer TS150 FDD to 2.5'' HDD
convertor kit (hereinafter called the 2.5-inch convertor kit).
Figure 36. Removing the drive from the 2.5-inch convertor kit
6. Install a new drive or install a metal shield to cover the drive bay.
7. If you are instructed to return the old drive, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
Installing a storage drive into drive bay 3
Note: Drive bay 3 supports only a 2.5-inch hard disk drive or solid-state drive.
To install the storage drive, do the following:
Chapter 5. Replacing hardware 57
To Next Page
Loading...
