Table 3. Events organized by severity (continued)
Event ID
Message String Severity
FQXSFIO0006I An inter-board UPI has been disabled on the link between processor
[arg1] port [arg2] and processor [arg3]port [arg4] because of UPI
topology downgrade.
Informational
FQXSFIO0015I IFM: System reset performed to reset adapters. Informational
FQXSFIO0018I IFM: Configuration too large for compatibility mode. Informational
FQXSFIO0020J PCIe Isolation has occurred in PCIe slot [arg1]. The adapter may not
operate correctly.
Informational
FQXSFMA0001I DIMM [arg1] Disable has been recovered. [arg2] Informational
FQXSFMA0002I
The uncorrectable memory error state has been cleared. Informational
FQXSFMA0006I [arg1] DIMM [arg2] has been detected, the DIMM serial number is
[arg3].
Informational
FQXSFMA0007I [arg1] DIMM number [arg2] has been replaced. [arg3] Informational
FQXSFMA0008I DIMM [arg1] POST memory test failure has been recovered. [arg2] Informational
FQXSFMA0009I Invalid memory configuration for Mirror Mode has been recovered.
[arg1]
Informational
FQXSFMA0010I Invalid memory configuration for Sparing Mode has been recovered.
[arg1]
Informational
FQXSFMA0011I Memory population change detected. [arg1] Informational
FQXSFMA0012I The PFA of DIMM [arg1] has been deasserted. Informational
FQXSFMA0013I Mirror Fail-over complete. DIMM [arg1] has failed over to to the
mirrored copy. [arg2]
Informational
FQXSFMA0014I Memory spare copy initiated. [arg1] Informational
FQXSFMA0015I Memory spare copy has completed successfully. [arg1] Informational
FQXSFMA0026I DIMM [arg1] Self-healing, attempt post package repair (PPR)
succeeded at Rank [arg2] Sub Rank [arg3] Bank [arg4] Row [arg5] on
Device [arg6]. [arg7]
Informational
FQXSFMA0027I Invalid memory configuration (unsupported DIMM Population)
recovered.
Informational
FQXSFMA0029I The PFA of DIMM [arg1] has been deasserted after applying PPR for
this DIMM. [arg2]
Informational
FQXSFMA0046I DIMM [arg1] is Intel Optane PMEM and its volatile or non-volatile
capacity will be inaccessible because that configuration mode is not
supported on current platform.
Informational
FQXSFMA0052I DIMM [arg1] has been disabled due to the error on DIMM [arg2].[arg3] Informational
FQXSFMA0053I DIMM [arg1] re-enabled due to memory module combination
updating.
Informational
FQXSFMA0065I Multi-bit CE of DIMM [arg1] has been deasserted after performing
post package repair. DIMM identifier is [arg2].
Informational
FQXSFPU0020I The UEFI firmware image capsule signature is invalid. Informational
FQXSFPU0021I The TPM physical presence state has been cleared. Informational
138 ThinkSystem SE350 V2 Messages and Codes Reference
To Next Page
Loading...
