Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPPW0104J Non-redundant:Sufficient Resources from Redundancy Degraded or
Fully Redundant for [RedundancySetElementName] has asserted.
Warning
FQXSPPW0118J The current chassis configuration is not supported for PMEM
operation.
Warning
FQXSPPW0119J Compute node has been gracefully shutdown while CMM is in failsafe
mode with PMEM ADR complete to prevent data lost.
Warning
FQXSPPW0120J Unsupported PSU configuration.CPU power has been capped to
125W.
Warning
FQXSPPW0122J CMM firmware update required for SN550 V2 support.
Warning
FQXSPSD0002G Failure Predicted on [StorageVolumeElementName] for array
[ComputerSystemElementName].
Warning
FQXSPSD0003G Failure Predicted on drive [arg1] in the enclosure/chassis (MTM-SN:
[arg2]).
Warning
FQXSPUN0009G Sensor [SensorElementName] has asserted. Warning
FQXSPUN0018J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
Warning
FQXSPUN0026G Device [LogicalDeviceElementName] has been added.
Warning
FQXSPBR4003I Platform Watchdog Timer expired for [arg1].
Error
FQXSPBR4007I Management Controller [arg1]: Configuration restoration from a file by
user [arg2] failed to complete.
Error
FQXSPBR4008I Management Controller [arg1]: Configuration restoration from a file by
user [arg2] failed to start.
Error
FQXSPCA0002M Numeric sensor [NumericSensorElementName] going low (lower
critical) has asserted.
Error
FQXSPCA0009M Numeric sensor [NumericSensorElementName] going high (upper
critical) has asserted.
Error
FQXSPCA0011N Numeric sensor [NumericSensorElementName] going high (upper
non-recoverable) has asserted.
Error
FQXSPCA0017M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPCA0019N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
Error
FQXSPCR0001N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
Error
FQXSPEA0002M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPFW0000N The System [ComputerSystemElementName] encountered a POST
Error.
Error
FQXSPFW0001N Firmware BIOS (ROM) corruption was detected on system
[ComputerSystemElementName] during POST.
Error
FQXSPFW0002N The System [ComputerSystemElementName] encountered a firmware
hang.
Error
20 ThinkSystem SN550 V2 Messages and Codes Reference
To Next Page
Loading...
