• FQXSPCN4002I: User [arg1] has terminated an active console session.
A user has terminated an active console session
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0145
User Action:
Information only; no action is required.
• FQXSPCN4003I: Remote Control session started by user [arg1] in [arg2] mode has been closed.
Remote Control session closed
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0194
User Action:
Information only; no action is required.
• FQXSPCR0001N: Sensor [SensorElementName] has transitioned to non-recoverable from a less
severe state.
This message is for the use case when an implementation has detected a Sensor transitioned to non-
recoverable from less severe.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0524
User Action:
Complete the following steps:
1. Please flash uEFI image to the latest level.
2. If the problem still exists, please remove and re-install CMOS battery for 30 seconds to clear CMOS
contents.
3. If the problem still exists, please contact Lenovo service.
• FQXSPCR2001I: Sensor [SensorElementName] has deasserted the transition to non-recoverable
from a less severe state.
This message is for the use case when an implementation has detected that the Sensor transition to non-
recoverable from less severe has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
Chapter 2. XClarity Controller events 31
To Next Page
Loading...
