Lenovo ThinkSystem SR250 V3 - Page 120

Make sure that the correct login ID and password are being used.
• FQXSPSE4006I: XCC detected an invalid SSL certificate in the Management Controller [arg1] .
This message is for the use case where a Management Controller has detected invalid SSL data in the
configuration data and is clearing the configuration data region and disabling the SSL.
Severity: Error
Serviceable: No
Automatically notify Support: No
Alert Category: System - other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0034
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the certificate that you are importing is correct and properly generated / certificate
CSR is correct
2. If problem persists, collect Service Data log.
3. Contact Lenovo Support.
• FQXSPSE4007I: Security: Userid: [arg1] using [arg2] had [arg3] login failures from an SSH client at
IP address [arg4].
This message is for the use case where a user has failed to log in to a Management Controller from SSH.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0041
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the correct login ID and password are being used.
2. Have the system administrator reset the login ID or password.
• FQXSPSE4008I: SNMPv1 [arg1] set by user [arg2]: Name=[arg3], AccessType=[arg4], Address=
[arg5], .
A user changed the SNMP community string
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0075
User Action:
Information only; no action is required.
• FQXSPSE4009I: LDAP Server configuration set by user [arg1]: SelectionMethod=[arg2],
DomainName=[arg3], Server1=[arg4], Server2=[arg5], Server3=[arg6], Server4=[arg7].
A user changed the LDAP server configuration
116
ThinkSystem SR250 V3 Messages and Codes Reference