Lenovo ThinkSystem SR250 V3 - Page 166

• FQXSFPU4052G: TPM_TCM_POLICY is not locked
Severity: Warning
User Action:
Complete the following steps:
1. Reboot the system.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU4053G: System TPM_TCM_POLICY does not match the planar.
Severity: Warning
User Action:
Complete the following steps:
1. Remove any newly added TPM/TCM card from the planar or re-install the original TPM/TCM card
that shipped with the system.
2. Reboot the system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU4054G: TPM/TCM card logical binding has failed.
Severity: Warning
User Action:
Complete the following steps:
1. Reboot the system.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU4056M: TPM/TCM card is changed, need install back the original TCM/TPM card which
shipped with the system.
Severity: Error
User Action:
Complete the following steps:
1. Re-install the original TCM/TPM card that shipped with the system.
2. Reboot the system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU4059I: User requested to skip freezing lock of AHCI-attached SATA drives. System UEFI
accepted the request and will execute priot to OS boot.
Severity: Info
User Action:
Complete the following steps:
1. Change SystemOobCustom.SkipAhciFreezeLock from Disable to Enable using OneCLI tool.(use
OneCLI command “OneCli config set SystemOobCustom.SkipAhciFreezeLock “Enabled” --imm
IMM_USERID:IMM_PASSWORD@IMM_IP --override”).
2. Reboot the system into OS.
• FQXSFPU4060I: Skipped freezing lock of AHCI-attached SATA drives.
162
ThinkSystem SR250 V3 Messages and Codes Reference