Lenovo ThinkSystem SR250 V3 - Page 26

Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPUN0048I The RAID controller in PCI slot [arg1] in optimal status. Informational
FQXSPUN2009I Sensor [SensorElementName] has deasserted. Informational
FQXSPUN2012I Sensor [SensorElementName] has deasserted. Informational
FQXSPUN2018I Sensor [SensorElementName] has deasserted the transition from
normal to non-critical state.
Informational
FQXSPUN2019I Sensor [SensorElementName] has transitioned to a less severe state
from critical.
Informational
FQXSPUN2023I Sensor [SensorElementName] has deasserted the transition to non-
recoverable.
Informational
FQXSPUN2049I The RAID controller in PCI slot [arg1] is no longer in warning status. Informational
FQXSPUN2050I The RAID controller in PCI slot [arg1] is no longer in critical status. Informational
FQXSPUP0002I A firmware or software change occurred on system
[ComputerSystemElementName].
Informational
FQXSPUP4001I Flash of [arg1] from [arg2] succeeded for user [arg3] . Informational
FQXSPUP4002I Flash of [arg1] from [arg2] failed for user [arg3]. Informational
FQXSPUP4006I Auto promote primary XCC to backup is [arg1] by user [arg2] from
[arg3] at IP address [arg4].
Informational
FQXSPWD0000I Watchdog Timer expired for [WatchdogElementName]. Informational
FQXSPWD0001I Reboot of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
Informational
FQXSPWD0002I Powering off system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
Informational
FQXSPWD0003I Power cycle of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
Informational
FQXSPWD0004I Watchdog Timer interrupt occurred for [WatchdogElementName]. Informational
FQXSPBR4001I Running the backup Management Controller [arg1] main application.
Warning
FQXSPCA0007J Numeric sensor [NumericSensorElementName] going high (upper
non-critical) has asserted.
Warning
FQXSPCA0015J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
Warning
FQXSPDM4002I Device [arg1] VPD is not valid. Warning
FQXSPEA0001J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
Warning
FQXSPEA0003J Link down is detected on port [arg1] of the PCIe device [arg2].
Warning
FQXSPIO0014J Bus [SensorElementName] is operating in a degraded state. Warning
FQXSPIO2000J The connector [PhysicalConnectorElementName] has been
disconnected.
Warning
FQXSPIO4001I GPU Board Status was changed by [arg1] of [arg1].
Warning
FQXSPMA0010J [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] Throttled.
Warning
22 ThinkSystem SR250 V3 Messages and Codes Reference