Table 15. Components on the rear of the server (continued)
Callout Callout
7 USB 3.2 Gen 1 (5Gbps) connectors (3 DCIs) 8 XClarity Controller network connector
9 Ethernet connectors on OCP module (optional, two or
four connectors may be available)
Figure 4. Rear view with one low profile PCIe adapter, one filler, and one full height PCIe adapter
Table 16. Components on the rear of the server
Callout Callout
1 PCIe slot 1 on riser 1 assembly 2 PCIe slot 3 on riser 2 assembly
3 Power supply 2 (optional)
4 Power supply 1
5 NMI button
6 VGA connector
7 USB 3.2 Gen 1 (5Gbps) connectors (3 DCIs) 8 XClarity Controller network connector
9 Ethernet connectors on OCP module (optional, two or
four connectors may be available)
Note: For more information about each component, see
“Rear components overview” on page 30.
Server model with two 2.5-inch hot-swap rear drive bays and one PCIe slot
The following illustration shows the rear view of the server model with two hot-swap drive bays and one PCIe
slot. Depending on the model, your server might look slightly different from the illustration below.
Table 17. Components on the rear of the server
1 PCIe slot 1 on riser 1 assembly 2 Rear 2.5-inch drive bays (2)
3 Power supply 2 (optional)
4 Power supply 1
5 NMI button
6 VGA connector
7 USB 3.2 Gen 1 (5Gbps) connectors (3 DCIs) 8 XClarity Controller network connector
9 Ethernet connectors on OCP module (optional, two or
four connectors may be available)
Note: For more information about each component, see
“Rear components overview” on page 30.
28
ThinkSystem SR630 V3 System Configuration Guide
To Next Page
Loading...
