Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPIO0010I A Correctable Bus Error has occurred on bus [SensorElementName]. Informational
FQXSPIO2002I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
Informational
FQXSPIO2003I System [ComputerSystemElementName] has recovered from a
diagnostic interrupt.
Informational
FQXSPIO2004I Bus [SensorElementName] has recovered from a bus timeout. Informational
FQXSPIO2006I System [ComputerSystemElementName] has recovered from an NMI. Informational
FQXSPIO2010I Bus [SensorElementName] has recovered from a Correctable Bus
Error.
Informational
FQXSPIO2013I Bus [SensorElementName] has recovered from a Fatal Bus Error. Informational
FQXSPIO2015I Fault condition removed on slot [PhysicalConnectorElementName] on
system [ComputerSystemElementName].
Informational
FQXSPIO4001I GPU Board Status was changed by [arg1] of [arg1]. Informational
FQXSPIO4002I GPU Board Status was recovered by [arg1] of [arg1]. Informational
FQXSPMA0009I Memory sparing initiated for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
Informational
FQXSPMA0022I Memory sparing initiated for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
Informational
FQXSPMA2005I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
Informational
FQXSPMA2006I Parity Error Recovery for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
Informational
FQXSPMA2007I Scrub Failure for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] has recovered.
Informational
FQXSPMA2010I [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] is no longer Throttled.
Informational
FQXSPMA2012I An Over-Temperature Condition has been removed on the
[PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
Informational
FQXSPMA2013I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
Informational
FQXSPNM4000I Management Controller [arg1] Network Initialization Complete. Informational
FQXSPNM4001I Ethernet Data Rate modified from [arg1] to [arg2] by user [arg3]. Informational
FQXSPNM4002I Ethernet Duplex setting modified from [arg1] to [arg2] by user [arg3]. Informational
FQXSPNM4003I Ethernet MTU setting modified from [arg1] to [arg2] by user [arg3]. Informational
FQXSPNM4004I Ethernet locally administered MAC address modified from [arg1] to
[arg2] by user [arg3].
Informational
FQXSPNM4005I Ethernet interface [arg1] by user [arg2]. Informational
FQXSPNM4006I Hostname set to [arg1] by user [arg2]. Informational
Chapter 2. XClarity Controller events 9
To Next Page
Loading...
