Complete the following steps until the problem is solved:
1. Retry the operation.
2. AC cycle the system.
3. If Problem persists, collect Service Data log.
4. Contact Lenovo Support.
• FQXSPBR4008I: Management Controller [arg1]: Configuration restoration from a file by user [arg2]
failed to start.
This message is for the use case where a user restores a Management Controller configuration from a file
and the restoration fails to start.
Severity: Error
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0138
User Action:
Complete the following steps until the problem is solved:
1. Check if password for encrypted backup config file is correct.
2. Retry the operation.
3. AC cycle the system.
4. If problem persists, collect Service Data log.
5. Contact Lenovo Support.
• FQXSPBT0007I: No bootable media available for system [ComputerSystemElementName].
This message is for the use case when an implementation has detected a System with No Bootable
Media.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0286
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the drive type is supported by the system.
2. Make sure that the bootable media is installed correctly.
3. Make sure that the UEFI boot mode is set correctly.
4. Make sure that the boot device is set within the UEFI boot sequence.
• FQXSPCA0002M: Numeric sensor [NumericSensorElementName] going low (lower critical) has
asserted.
This message is for the use case when an implementation has detected a Lower Critical sensor going low
has asserted.
Severity: Error
Serviceable: Yes
Chapter 2. XClarity Controller events 25
To Next Page
Loading...
