Lenovo ThinkSystem SR650 V2 - Page 92

CIM Prefix: PLAT CIM ID: 0476
User Action:
Complete the following steps until the problem is solved:
1. Remove the CMOS battery for 20 seconds and then install it back.
2. If the problem persists, contact Lenovo Support.
• FQXSPPW0035M: Numeric sensor [NumericSensorElementName] going low (lower critical) has
asserted.
This message is for the use case when an implementation has detected a Lower Critical sensor going low
has asserted.
Severity: Error
Serviceable: Yes
Automatically notify Support: Yes
Alert Category: Critical - Voltage
SNMP Trap ID: 1
CIM Prefix: PLAT CIM ID: 0480
User Action:
Complete the following steps until the problem is solved:
1. If the sensor is "CMOS Battery":
a. Reboot the XCC.
b. Reseat the CMOS battery.
c. If the problem persists, replace the CMOS battery.
2. If the sensor is "SysBrd 3.3V/5V/12V":
a. Do virtual AC cycle through the XCC/BMC.
b. If problem persists, collect service data log.
c. AC cycle the system.
d. If the problem still persists, collect service data log and contact Lenovo Support.
• FQXSPPW0047M: Numeric sensor [NumericSensorElementName] going high (upper critical) has
asserted.
This message is for the use case when an implementation has detected an Upper Critical sensor going
high has asserted.
Severity: Error
Serviceable: Yes
Automatically notify Support: Yes
Alert Category: Critical - Voltage
SNMP Trap ID: 1
CIM Prefix: PLAT CIM ID: 0494
User Action:
If the system has a standby power supply, collect service data log from the XCC WebGUI and contact
Lenovo Support.
• FQXSPPW0057J: Sensor [SensorElementName] has transitioned from normal to non-critical state.
This message is for the use case when an implementation has detected a Sensor transitioned to non-
critical from normal.
88
ThinkSystem SR650 V2 Messages and Codes Reference