Information only; no action is required.
• FQXSPPW2008I: [PowerSupplyElementName] has been turned on.
This message is for the use case when an implementation has detected a Power Unit that has been
Enabled.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Power On
SNMP Trap ID: 24
CIM Prefix: PLAT CIM ID: 0107
User Action:
Information only; no action is required.
• FQXSPPW2031I: Numeric sensor [NumericSensorElementName] going low (lower non-critical) has
deasserted.
This message is for the use case when an implementation has detected a Lower Non-critical sensor going
low has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Voltage
SNMP Trap ID: 13
CIM Prefix: PLAT CIM ID: 0477
User Action:
Information only; no action is required.
• FQXSPPW2035I: Numeric sensor [NumericSensorElementName] going low (lower critical) has
deasserted.
This message is for the use case when an implementation has detected a Lower Critical sensor going low
has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Voltage
SNMP Trap ID: 1
CIM Prefix: PLAT CIM ID: 0481
User Action:
Information only; no action is required.
• FQXSPPW2047I: Numeric sensor [NumericSensorElementName] going high (upper critical) has
deasserted.
This message is for the use case when an implementation has detected an Upper Critical sensor going
high has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Voltage
Chapter 2. XClarity Controller events 93
To Next Page
Loading...
