The following tables list supported internal storage configurations with the SAS/SATA and AnyBay backplanes.
Internal storage configurations tables conventions:
The numbers in brackets (x or x+y or x+y+z) in the Storage controller column specify the quantity of
drive bays connected to each of the controllers.
1x NVMe (4) in the Storage controller column represents the onboard NVMe controller.
2x NVMe (4+4) in the Storage controller column represents the onboard NVMe controller and NVMe
Switch adapter.
3x NVMe (4+4+4) in the Storage controller column represents the onboard NVMe controller and two
NVMe Switch adapters.
Table 14. Internal storage configurations: Up to 16 SFF front drive bays without rear drive bays
Hot-swap drive bay
configuration
Backplane kit type and quantity
Storage controller type and quantity
8x2.5"
SATA/
SAS
8x2.5"
Any
Bay
2x3.5"
Rear
HDD
16x 2.5" chassis (Feature code AUVX) or 24x 2.5" chassis (Feature code AUVV)
8x 2.5" SAS/SATA (front) 1 0 0 1x RAID 530/730-8i (8)
1x RAID 930-8i/16i/24i (8)
1x 430-8i/16i HBA (8)
4x 2.5" SAS/SATA (front) +
4x 2.5" AnyBay (front)
0 1 0 1x RAID 930-8i/16i/24i (8) + 1x NVMe (4)
1x 430-8i/16i HBA (8) + 1x NVMe (4)
16x 2.5" SAS/SATA (front) 2 0 0 1x RAID 930-16i/24i (16)
1x RAID 530/730-8i (8) + 1x 430-8i HBA (8)
2x RAID 530/730-8i (8+8)
2x RAID 930-8i (8+8)
2x 430-8i HBA (8+8)
12x 2.5" SAS/SATA (front) +
4x 2.5" AnyBay (front)
1 1 0 1x RAID 930-16i (16) + 1x NVMe (4)
1x 430-16i HBA (16) + 1x NVMe (4)
8x 2.5" SAS/SATA (front) +
8x 2.5" AnyBay (front)
0 2 0 1x RAID 930-16i/24i (16) + 2x NVMe (4+4)
1x 430-16i HBA (16) + 2x NVMe (4+4)
2x RAID 930-8i (8+8) + 2x NVMe (4+4)
2x 430-8i HBA (8+8) + 2x NVMe (4+4)