Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPIO0016I Identifying slot [PhysicalConnectorElementName] on system
[ComputerSystemElementName].
Informational
FQXSPIO2001I The connector [PhysicalConnectorElementName] configuration error
has been repaired.
Informational
FQXSPIO2003I System [ComputerSystemElementName] has recovered from a
diagnostic interrupt.
Informational
FQXSPIO2004I Bus [SensorElementName] has recovered from a bus timeout. Informational
FQXSPIO2006I System [ComputerSystemElementName] has recovered from an NMI. Informational
FQXSPIO2007I A PCI PERR recovery has occurred on system
[ComputerSystemElementName].
Informational
FQXSPIO2008I A PCI SERR on system [ComputerSystemElementName] has
deasserted.
Informational
FQXSPIO2010I Bus [SensorElementName] has recovered from a Correctable Bus
Error.
Informational
FQXSPIO4003I The PCIe switch has changed to normal mode by user [arg1] from
[arg2] at IP address [arg3].
Informational
FQXSPIO4004I The PCIe switch has changed to update-ready mode by user [arg1]
from [arg2] at IP address [arg3].
Informational
FQXSPMA0022I Post Package Repair Success for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
Informational
FQXSPMA0025I Sensor [SensorElementName] has asserted. Informational
FQXSPMA2001I Error Detected and Corrected for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName] has deasserted.
Informational
FQXSPMA2007I Scrub Failure for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] has recovered.
Informational
FQXSPMA2010I [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] is no longer Throttled.
Informational
FQXSPMA2012I An Over-Temperature Condition has been removed on the
[PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
Informational
FQXSPMA2024I Sensor [SensorElementName] has deasserted. Informational
FQXSPNM4000I Management Controller [arg1] Network Initialization Complete. Informational
FQXSPNM4001I Ethernet Data Rate modified from [arg1] to [arg2] by user [arg3]. Informational
FQXSPNM4002I Ethernet Duplex setting modified from [arg1] to [arg2] by user [arg3]. Informational
FQXSPNM4003I Ethernet MTU setting modified from [arg1] to [arg2] by user [arg3]. Informational
FQXSPNM4004I Ethernet locally administered MAC address modified from [arg1] to
[arg2] by user [arg3].
Informational
FQXSPNM4005I Ethernet interface [arg1] by user [arg2]. Informational
FQXSPNM4006I Hostname set to [arg1] by user [arg2]. Informational
FQXSPNM4007I IP address of network interface modified from [arg1] to [arg2] by user
[arg3].
Informational
12 ThinkSystem SR685a V3 Messages and Codes Reference
To Next Page
Loading...
