Table 3. Events organized by severity (continued)
Event ID
Message String Severity
FQXSFPU4082I Host Admin password has been changed. Informational
FQXSFPU4083I
Host Admin password has been cleared. Informational
FQXSFPU4084I
Host boot order has been changed. Informational
FQXSFPU4085I Host WOL boot order has been changed. Informational
FQXSFSM0007I The XCC System Event log (SEL) is full. Informational
FQXSFSR0002I [arg1] GPT corruption recovered, DiskGUID: [arg2] Informational
FQXSFDD0001G DRIVER HEALTH PROTOCOL: Missing Configuration. Requires
Change Settings From F1.
Warning
FQXSFDD0002M DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller.
Warning
FQXSFDD0003I DRIVER HEALTH PROTOCOL: Reports 'Reboot' Required Controller.
Warning
FQXSFDD0005M DRIVER HEALTH PROTOCOL: Disconnect Controller Failed. Requires
'Reboot'.
Warning
FQXSFDD0006M DRIVER HEALTH PROTOCOL: Reports Invalid Health Status Driver. Warning
FQXSFDD0007G Security Key Lifecycle Manager (SKLM) IPMI Error.
Warning
FQXSFIO0013I The device found at Bus [arg1] Device [arg2] Function [arg3] could not
be configured due to resource constraints. The Vendor ID for the
device is [arg4] and the Device ID is [arg5]. The physical slot number
is [arg6].
Warning
FQXSFIO0021J PCIe Error Recovery has occurred in physical [arg1] number [arg2].
The [arg3] may not operate correctly.
Warning
FQXSFIO0022J PCIe Link Width has degraded from [arg1] to [arg2] in physical [arg3]
number [arg4].
Warning
FQXSFIO0023J PCIe Link Speed has degraded from [arg1] to [arg2] in physical [arg3]
number [arg4].
Warning
FQXSFIO0029G Correctable CPU link error has been detected on processor [arg1]. Warning
FQXSFMA0012L The [arg1] PFA Threshold limit has been exceeded on DIMM [arg2] at
address [arg3]. [arg4]
Warning
FQXSFMA0026G Multi-bit CE occurred on DIMM [arg1], need to restart the system for
DIMM Self-healing to attempt post package repair (PPR).
Warning
FQXSFMA0027G Multi-bit CE occurred on DIMM [arg1] different rows.[arg2]
Warning
FQXSFMA0027M DIMM [arg1] Self-healing, attempt post package repair (PPR) failed at
Rank [arg2] Sub Rank [arg3] Bank [arg4] Row [arg5] on Device [arg6].
[arg7]
Warning
FQXSFMA0028M DIMM [arg1] Self-healing, attempt post package repair (PPR)
exceeded DIMM level threshold [arg2] at Rank [arg3] Sub Rank [arg4]
Bank [arg5] Row [arg6] on Device [arg7]. [arg8]
Warning
FQXSFMA0047M SPD CRC checking failed on DIMM [arg1]. [arg2] Warning
FQXSFMA0048M DIMM [arg1] disabled due to PMIC failure during POST, DIMM
identifier is [arg2].
Warning
FQXSFMA0050G DRAM PFA threshold limit exceeded on DIMM [arg1] sub-channel
[arg2] Rank [arg3] DRAM [arg4], DIMM identifier is [arg5].
Warning
Chapter 3. UEFI events 163
To Next Page
Loading...
