• FQXSFMA0076M: DIMM [arg1] is not supported, DIMM identifier is [arg2].
Severity: Warning
Parameters:
[arg1] DIMM slot silk label
[arg2] DIMM identifier consists of S/N, FRU and UDI, e.g. "739E68ED-VC10 FRU 0123456"
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Check user manual for supported DIMM types and replace the DIMM specified by the message with
a supported one.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0019N: An uncorrectable error has been detected on processor [arg1].
Severity: Error
Parameters:
[arg1] Socket number, 1-based.
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Power off the system and remove A/C power.
3. Restore A/C power and power on the system.
4. Determine if there have been recent changes to the hardware, firmware or operating system. Reverse
them if possible.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0021G: Hardware physical presence is in asserted state.
Severity: Warning
User Action:
Complete the following steps:
1. Complete any administrative tasks requiring the TPM physical presence switch to be in the "ON"
position.
2. Restore the physical presence switch to the "OFF" position and reboot the system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0021I: The TPM physical presence state has been cleared.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU0022G: The TPM configuration is not locked.
Severity: Warning
User Action:
Chapter 3. UEFI events 183
To Next Page
Loading...
