Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPPP4010I The new minimum power cap value exceeded the power cap value. Warning
FQXSPPU0010G The Processor [ProcessorElementName] is operating in a Degraded
State due to [ProcessorElementName].
Warning
FQXSPPU0013G [ProcessorElementName] has correctable error. Warning
FQXSPPW0003G Failure predicted on [PowerSupplyElementName].
Warning
FQXSPPW0006I [PowerSupplyElementName] has lost input. Warning
FQXSPPW0031J Numeric sensor [NumericSensorElementName] going low (lower non-
critical) has asserted.
Warning
FQXSPPW0057J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
Warning
FQXSPPW0059J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
Warning
FQXSPPW0101J Redundancy Degraded for [RedundancySetElementName] has
asserted.
Warning
FQXSPPW0104J Non-redundant:Sufficient Resources from Redundancy Degraded or
Fully Redundant for [RedundancySetElementName] has asserted.
Warning
FQXSPPW4002I Total graphics power value has exceeded the pre-configured limit. Warning
FQXSPSD0002G Failure Predicted on [StorageVolumeElementName] for array
[ComputerSystemElementName].
Warning
FQXSPSD0003G Failure Predicted on drive [arg1] in the enclosure/chassis (MTM-SN:
[arg2]).
Warning
FQXSPSE0000F The Chassis [PhysicalPackageElementName] was opened.
Warning
FQXSPSE0010J System guard detected inventory mismatch with trusted snapshot.
Warning
FQXSPSE4006I XCC detected an invalid SSL certificate in the Management Controller
[arg1] .
Warning
FQXSPUN0009G Sensor [SensorElementName] has asserted. Warning
FQXSPUN0018J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
Warning
FQXSPUN0058J The remaining life for [arg1] is lower than the threshold [arg2].
Warning
FQXSPUN0059J Sensor [SensorElementName] has transitioned from normal to
warning state.
Warning
FQXSPUN0060G Sensor [SensorElementName] has asserted.
Warning
FQXSPBR4003I Platform Watchdog Timer expired for [arg1].
Error
FQXSPBR4007I Management Controller [arg1]: Configuration restoration from a file by
user [arg2] failed to complete from [arg3] at IP address [arg4].
Error
FQXSPBR4008I Management Controller [arg1]: Configuration restoration from a file by
user [arg2] failed to start from [arg3] at IP address [arg4].
Error
FQXSPCA0002M Numeric sensor [NumericSensorElementName] going low (lower
critical) has asserted.
Error
Chapter 2. XClarity Controller events 25
To Next Page
Loading...
