Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPUP4002I Flash of [arg1] from [arg2] failed for user [arg3]. Informational
FQXSPUP4006I Auto promote primary XCC to backup is [arg1] by user [arg2] from
[arg3] at IP address [arg4].
Informational
FQXSPUP4007I Violation access to XCC SPI flash is detected and isolated. Informational
FQXSPUP4008I Violation access to UEFI SPI flash is detected and isolated. Informational
FQXSPUP4010I Flash [arg1] of [arg2] from [arg3] succeeded for user [arg4] . Informational
FQXSPUP4011I Flash [arg1] of [arg2] from [arg3] failed for user [arg4]. Informational
FQXSPWD0000I Watchdog Timer expired for [WatchdogElementName]. Informational
FQXSPWD0001I Reboot of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
Informational
FQXSPWD0002I Powering off system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
Informational
FQXSPWD0003I Power cycle of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
Informational
FQXSPWD0004I Watchdog Timer interrupt occurred for [WatchdogElementName]. Informational
FQXSPBR4001I Running the backup Management Controller [arg1] main application.
Warning
FQXSPCA0007J Numeric sensor [NumericSensorElementName] going high (upper
non-critical) has asserted.
Warning
FQXSPDM4002I Device [arg1] VPD is not valid.
Warning
FQXSPEA0001J Sensor [SensorElementName] has transitioned from normal to non-
critical state.
Warning
FQXSPEA0003J Link down is detected on port [arg1] of the PCIe device [arg2].
Warning
FQXSPEM4040I Dust filter measurement is completed. The airflow pathway is
obstructed, check and replace the dust filter, or remove any
obstructing object.
Warning
FQXSPEM4043I A [arg1] failure has been detected and need [arg2] to recover. Warning
FQXSPIO0014J Bus [SensorElementName] is operating in a degraded state.
Warning
FQXSPMA0001I Error Detected and Corrected for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
Warning
FQXSPMA0010J [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] Throttled.
Warning
FQXSPMA0011G Memory Logging Limit Reached for [PhysicalMemoryElementName]
on Subsystem [MemoryElementName].
Warning
FQXSPMA0024G Sensor [SensorElementName] has asserted.
Warning
FQXSPMA4034G Health of DIMM [arg1] is in warning state and sub-state is [arg2].
Warning
FQXSPNM4010I DHCP[[arg1]] failure, no IP address assigned. Warning
FQXSPNM4032I DHCPv6 failure, no IP address assigned.
Warning
FQXSPPP4009I The measured power value exceeded the power cap value. Warning
24 ThinkSystem SR685a V3 Messages and Codes Reference
To Next Page
Loading...
