3. If drive is correctly seated, replace the drive.
Service Action:
Complete the following steps until the problem is solved:
1. Review PD Steps by confirming that the drive is correctly seated.
2. Replace the drive.
3. If problem persists, escalate to next level of support.
• FQXSPSD2001I: The [StorageVolumeElementName] has been enabled.
This message is for the use case when an implementation has detected a Drive was Enabled.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Hard Disk drive
SNMP Trap ID: 5
CIM Prefix: PLAT CIM ID: 0167
User Action:
Information only; no action is required
Service Action:
Information only; no action is required.
• FQXSPSD2002I: Failure no longer Predicted on [StorageVolumeElementName] for array
[ComputerSystemElementName].
This message is for the use case when an implementation has detected an Array Failure is no longer
Predicted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Predicted Failure
SNMP Trap ID: 27
CIM Prefix: PLAT CIM ID: 0169
User Action:
Information only; no action is required
Service Action:
Information only; no action is required.
• FQXSPSD2003I: Hot spare disabled for [ComputerSystemElementName].
This message is for the use case when an implementation has detected a Hot Spare has been Disabled.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
Chapter 2. XClarity Controller events 141
To Next Page
Loading...
