SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0179
User Action:
Information only; no action is required
Service Action:
Information only; no action is required.
• FQXSPSD2008I: Drive [arg1] in the enclosure/chassis(MTM-SN: [arg2]) has been enabled.
This message is for the use case when an implementation has detected a Drive was Enabled.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Hard Disk drive
SNMP Trap ID: 5
CIM Prefix: PLAT CIM ID: 0167
User Action:
Information only; no action is required
Service Action:
Information only; no action is required.
• FQXSPSD2010I: Drive [arg1] in the enclosure/chassis(MTM-SN: [arg2]) has been removed.
This message is for the use case when an implementation has detected a Drive has been Removed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: PLAT CIM ID: 0163
User Action:
Complete the following steps until the problem is solved:
1. If drive was intentionally removed, make sure that there is a filler in the drive bay.
2. Make sure that the drive is correctly seated.
3. If drive is correctly seated, replace the drive.
Service Action:
Complete the following steps until the problem is solved:
1. Review PD Steps by confirming that the drive is correctly seated.
2. Replace the drive.
3. If problem persists, escalate to next level of support.
• FQXSPSD2011I: Failure no longer Predicted on drive [arg1] in the enclosure/chassis (MTM-S/N:
[arg2]).
Chapter 2. XClarity Controller events 143
To Next Page
Loading...
