Lenovo ThinkSystem SR850 V2 - List of XClarity Controller events

Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPPW0110M Non-redundant:Insufficient Resources for
[RedundancySetElementName] has asserted.
Error
FQXSPSD0001L The [StorageVolumeElementName] has been disabled due to a
detected fault.
Error
FQXSPSD0002L Drive [arg1] in the enclosure/chassis(MTM-SN: [arg2]) has been
disabled due to a detected fault.
Error
FQXSPSD0005L Array [ComputerSystemElementName] is in critical condition.
Error
FQXSPSD0006L Array [ComputerSystemElementName] has failed.
Error
FQXSPSD0007L Array critical asserted on drive [arg1] in the enclosure/chassis (MTM-
S/N: [arg2]).
Error
FQXSPSD0008L Array failed on drive [arg1] in the enclosure/chassis (MTM-S/N: [arg2]).
Error
FQXSPSE4000I Certificate Authority [arg1] has detected a [arg2] Certificate Error.
Error
FQXSPSE4006I SSL data in the Management Controller [arg1] configuration data is
invalid. Clearing configuration data region and disabling SSL.
Error
FQXSPSR0001N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
Error
FQXSPUN0019M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPUN0023N Sensor [SensorElementName] has transitioned to non-recoverable.
Error
FQXSPUP0007L Invalid or Unsupported firmware or software was detected on system
[ComputerSystemElementName].
Error
FQXSPUP4000I Please ensure that the Management Controller [arg1] is flashed with
the correct firmware. The Management Controller is unable to match
its firmware to the server.
Error
FQXSPUP4003I [arg1] firmware mismatch internal to system [arg2]. Please attempt to
flash the [arg3] firmware.
Error
FQXSPUP4004I XCC firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the XCC firmware to the same level on all
nodes/servers.
Error
FQXSPUP4005I FPGA firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the FPGA firmware to the same level on all
nodes/servers.
Error
List of XClarity Controller events
This section lists all messages that can be sent from the XClarity Controller.
• FQXSPBR4000I: Management Controller [arg1]: Configuration restored from a file by user [arg2].
This message is for the use case where a user restores a Management Controller configuration from a file.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
22
ThinkSystem SR850 V2 System Events Service Guide