Table 3. Events organized by severity (continued)
Event ID
Message String Severity
FQXSFPU0031N The number of POST attempts has reached the value configured in F1
setup.The system has booted with default UEFI settings. User
specified settings have been preserved and will be used on
subsequent boots unless modified before rebooting.
Error
FQXSFPU0034L
The TPM could not be initialized properly. Error
FQXSFPU0035N A 3-strike timeout has occurred on processor [arg1]. Error
FQXSFPU4056M
TPM card is changed, need install back the original TPM card which
shipped with the system.
Error
FQXSFSM0008M Boot permission timeout detected. Error
List of UEFI events
This section lists all messages that can be sent from UEFI.
• FQXSFDD0001G: DRIVER HEALTH PROTOCOL: Missing Configuration. Requires Change Settings
From F1.
Severity: Warning
User Action:
Complete the following steps:
1. Go to F1 Setup > System Settings > Settings > Driver Health Status List and find a driver/controller
reporting Configuration Required status.
2. Search for the driver menu from System Settings and change settings appropriately.
3. Save settings and restart the system.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFDD0002M: DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller.
Severity: Warning
User Action:
Complete the following steps:
1. Reboot the system.
2. Reflash the adapter firmware.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFDD0003I: DRIVER HEALTH PROTOCOL: Reports 'Reboot' Required Controller.
Severity: Warning
User Action:
Complete the following steps:
1. No action required - system will reboot at the end of POST.
2. Reflash the adapter firmware.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFDD0004M: DRIVER HEALTH PROTOCOL: Reports 'System Shutdown' Required Controller.
148
ThinkSystem SR950 V3 Messages and Codes Reference
To Next Page
Loading...
