Lenovo ThinkSystem SR950 V3 - Page 176

Validate system’s memory configuration by using the memory configuration tool below: https://dcsc.
lenovo.com/#/memory_configuration.
• FQXSFMA0046I: DIMM [arg1] is Intel Optane PMEM and its volatile or non-volatile capacity will be
inaccessible because that configuration mode is not supported on current platform.
Severity: Info
Parameters:
[arg1]: Dimm Silk Label, 1-based
User Action:
Complete the following steps:
1. Power off the system.
2. Reconfig the Intel Optane PMEM.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFMA0046M: DIMM [arg1] is disabled because it is Intel Optane PMEM that is not supported
on current platform
Severity: Error
Parameters:
[arg1]: Dimm Silk Label, 1-based
User Action:
Complete the following steps:
1. Power off the system.
2. Remove the unsupported Intel Optane PMEM from this system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFMA0047M: SPD CRC checking failed on DIMM [arg1]. [arg2]
Severity: Warning
Parameters:
[arg1]: Dimm Silk Label, 1-based [arg2]: DIMM info (S/N, FRU and UDI.), e.g. "739E68ED-VC10 FRU
0123456"
User Action:
Complete the following steps:
1. Perform a virtual reseat or AC cycle the server.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFMA0052I: DIMM [arg1] has been disabled due to the error on DIMM [arg2].[arg3]
Severity: Info
Parameters:
[arg1]: Dimm Silk Label, 1-based [arg2]: Dimm Silk Label, 1-based [arg3]: DIMM info (S/N, FRU and UDI.),
e.g. "739E68ED-VC10 FRU 0123456"
User Action:
172
ThinkSystem SR950 V3 Messages and Codes Reference