Table 4. Events organized by severity (continued)
Event ID
Message String Severity
FQXPMER0006M Failed to load XCC factory default settings Error
FQXPMSD0001M HDD Test was interrupted by the host with a hardware or software
reset
Error
FQXPMSD0002M A fatal error or unknown test error occurred while the device was
executing its self-test
Error
FQXPMSD0003M self-test completed having a test element that failed and the test
element that failed is not known.
Error
FQXPMSD0004M self-test completed having the electrical element of the test failed. Error
FQXPMSD0005M self-test completed having the servo (and/or seek) test element of the
test failed.
Error
FQXPMSD0006M self-test completed having the read element of the test failed. Error
FQXPMSD0007M Hard Drive(s) not found
Error
FQXPMSD0008M UEFI is not ready for LXPM to send command to test hard drive. Error
FQXPMSD0009M Device error detected when LXPM sent a test command to a hard
drive.
Error
FQXPMSD0010M
UEFI timed out when LXPM sent a test command to a hard drive. Error
FQXPMSD0011M
The hard drive is not supported by uEFI while LXPM send command
to test hard drive.
Error
FQXPMUP0201M BMC communication failed: EMMC2USB mount failure. Failed to
update the firmware
Error
FQXPMUP0202M Transfer the update package error. Failed to update the firmware Error
FQXPMUP0203M BMC communication failed: EMMC2USB unmount failure. Failed to
update the firmware
Error
FQXPMUP0204M BMC communication failed: Execute the update cmd failure. Failed to
update the firmware
Error
FQXPMUP0205M BMC communication failed: Get the update status failure.Failed to
update the firmware
Error
FQXPMUP0206M The level of the update package is too old. Failed to update the
firmware.
Error
FQXPMUP0207M The update package is invalid. Failed to update the firmware. Error
FQXPMUP0208M Failed to execute reboot BMC command
Error
List of XClarity Provisioning Manager events
This section lists all messages that can be sent from the Lenovo XClarity Provisioning Manager.
• FQXPMCL0001K: Bootx64.efi is not found. Failed to Boot OS.
Severity: Warning
User Action:
1. Restart BMC via supported method and reboot the system.
2. If the problem persists, reflash BMC firmware.
192
ThinkSystem SR950 V3 Messages and Codes Reference
To Next Page
Loading...
