User Action:
Complete the following steps until the problem is solved:
1. Check if the OS watchdog is enabled
2. Check if the crash video recording is enabled
3. If problem persists, collect Service Data log.
4. Contact Lenovo Support.
• FQXSPOS4011I: OS failure screen capture with hardware error is [arg1] by user [arg2] from [arg3]
at IP address [arg4].
OS failure screen capture with hardware error is enabled or disabled by user.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0280
User Action:
Information only; no action is required.
• FQXSPPP4000I: Attempting to [arg1] server [arg2] by user [arg3].
This message is for the use case where a user is using the Management Controller to perform a power
function on the system.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0015
User Action:
Information only; no action is required.
• FQXSPPP4001I: Server Power Off Delay set to [arg1] by user [arg2].
A user configured the Server Power Off Delay
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0081
User Action:
Information only; no action is required.
• FQXSPPP4002I: Server [arg1] scheduled for [arg2] at [arg3] by user [arg4].
A user configured a Server Power action at a specific time
Severity: Info
Serviceable: No
Chapter 2. XClarity Controller events 79
To Next Page
Loading...
