Warning:
Assembly of the ride-on must be completed by an adult.
To avoid suffocation or choking, keep all bags and small parts away from babies and children.
1 x screwdriver is required for assembly. Screwdriver is not included.
2 x socket wrench are included.
Driving wheel installation:
●Turn the ride‐on upside down as shown in the image above.
●Put an axle sleeve and a gasket into the wheel.
●Push the wheel to the back axle and make the wheel connect well with the motor.
●Put an axle sleeve and a gasket to the other side of the wheel
●Tighten the wheel with a M10 nut.
● Insert the wheel cover.
●The other wheel is to be installed in the same way.
Front wheel installation:
● Turn the ride‐on upside down as shown in the image above.
●First put an axle sleeve and a gasket into the wheel.
To Next Page
Loading...