OPERATION:
INSTRUCTIONS FOR USE WITH A SPRING WATER BOTTLE (NOT INCLUDED):
Please follow the instructions below if you are using a spring water bottle.
Do not turn on the water cooler until the following instructions have been followed.
1. Vertically insert a spring water bottle into the bottle support on top of the water cooler. The
spoke will pierce the bottle cap. You will see bubbles appear inside the bottle, wait until the
bubbling has stopped before dispensing water from both taps.
Note: If you are applying a spring water bottle to the water cooler for the first time and you do not
see any bubbles appear inside the bottle, open both taps until the bubbling starts and water flows
from both taps.
2. Once the bubbling has stopped, drain 1 – 2 litres of water from both taps.
Note: The water cooler has been flushed before it left the factory however we strongly recommend
that 2 – 3 litres of water is flushed through the unit before use.
3. Insert the power plug into the wall socket and turn the power switch on the rear of the unit
to the on position.
4. At the front of the unit, there are 3 indicator lights.
The power on light will continually illuminate while the unit is turned on.
The cooling light will illuminate while the compressor is running and cooling the water.
When cooling is finished, the cooling light will turn off and the cold light will illuminate until
cooling is required again.
5. When the unit is on for the first time, allow the unit to cool the water for 1 – 2 hours before
dispensing cold water.
INSTRUCTIONS FOR USE WITH THE FILTER BOTTLE:
Please follow the instructions below if you are using the filter bottle.
Do not turn on the water cooler until the following instructions have been followed.
1. Remove the bottle support and spike from the water cooler.
2. To remove the bottle support, turn the bottle support in the direction of the OPEN arrow to
unlock and then hold the bottle support and vertically pull it off.
To Next Page
Loading...