Lenz Digital Plus STANDARD PLUS V2 - Page 36

36 Information STANDARD+ V2 Decoder
29
Bit
Settings 1
6 (dec)
1 (0)
Direction of travel
0 normal: locomotive drives forward if the arrow on the manual
control points up.
1 interchanged: locomotive drives forward if the arrow on the
manual control points down.
0
2 (1)
Running-notches mode:
0 Operation with 14 or 27 running notches.
This setting is chosen for digital systems which do not
support the 28 running-notches mode.
1
1 Operation with 28 or 128 running notches.
This setting is chosen for digital systems which support the
28/128 running-notches mode.
3 (2)
Operational mode:
0 Locomotive only runs in digital operation.
1 Locomotive runs both in digital and conventional operation,
flying splice possible.
1
4 (3)
0 RailCom transmission disabled
1 RailCom transmission enabled
0
5 (4)
0 factory pre-set speed curve is used
1 User defined speed curve is used
0
6 (5)
0 Decoder uses basic address (from CV1)
1 Decoder uses extended address (from CV17 and CV18)
0
7-8(6-7)
Not used
0
30
Bit
Fault display
0 (dec)